Engine Stator Cover Gasket For Yamaha Big Bear 350 400 Wolverine 350 1995-2012

Engine Stator Cover Gasket for Yamaha

This engine stator cover gasket provides a secure seal between the outer engine casing and the stator housing to prevent oil leaks.

Overview

The engine stator cover gasket seals the crankcase oil within the stator compartment to prevent external leaks. Installing a fresh engine stator cover gasket is essential during stator replacements or flywheel maintenance. This reliable engine stator cover gasket is designed for ATV riders who need dependable protection against dirt and moisture intrusion.

Built For Performance

• Precision-cut material to match stator cover bolt hole alignment
• High-temperature resistance to withstand demanding engine heat cycles
• Resists degradation when exposed to engine lubricants and chemicals
• Engineered to compress evenly to eliminate uneven clamping gaps

Fits These Machines

• for Yamaha Big Bear 350 1995-1999
• for Yamaha Big Bear 400 2000-2012
• for Yamaha Wolverine 350 1995-2009

On-The-Job Use

• Sealing the engine block during stator or pickup coil replacement
• Preventing engine oil leaks onto the surrounding chassis during off-road use
• Protecting internal electrical components from trail water and dust

Specs At A Glance

Good To Know

Q: Is it necessary to scrape off the old gasket residue before installation? A: Yes, the mating surfaces must be completely clean and smooth to ensure a reliable seal.

Q: Can this gasket be installed without adding liquid sealant? A: This gasket is designed to seal dry, but a thin layer of sealant can be used in corner joints if specified by the service manual.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.