Fan Cover Frame Cooling Radiator Assembly For Can-Am Maverick X3 2017-2024 2025

Fan Cover Frame Cooling Radiator Assembly for Can-Am

This fan cover frame cooling radiator assembly is a direct-fit replacement unit that mounts the cooling fan and shroud to the radiator, keeping airflow sealed and steady for Can-Am Maverick X3 machines from 2017 through 2025.

Overview

This fan cover frame cooling radiator assembly replaces a cracked, warped, or missing fan shroud on the Can-Am Maverick X3 so the cooling fan pulls air through the radiator instead of around it. The frame holds the fan in alignment and protects the blades from debris kicked up on the trail. It suits riders maintaining or rebuilding a side-by-side cooling system.

Built For Performance

• Direct bolt-on replacement for the factory fan cover frame assembly
• Rigid frame construction keeps the fan centered against the radiator core
• Sealed shroud design helps the fan pull air through the full core area
• Molded mounting points match stock radiator fan bolt locations
• Finished surfaces resist corrosion from mud, water, and trail spray
• Complete assembly arrives ready for installation with no fabrication required

Fits These Machines

• for Can-Am Maverick X3 2017
• for Can-Am Maverick X3 2018
• for Can-Am Maverick X3 2019
• for Can-Am Maverick X3 2020
• for Can-Am Maverick X3 2021
• for Can-Am Maverick X3 2022
• for Can-Am Maverick X3 2023
• for Can-Am Maverick X3 2024
• for Can-Am Maverick X3 2025

On-The-Job Use

• Replacing a damaged or missing fan shroud after a hard trail ride
• Restoring airflow during cooling system repairs or rebuilds
• Keeping fan blades protected from rocks, brush, and mud
• Preventing overheating on slow, technical terrain and long climbs

Specs At A Glance

Good To Know

Q: Will this fan cover frame fit my Maverick X3? A: It is built for Can-Am Maverick X3 models from 2017 through 2025, but trim and serial number differences can affect fit, so verify your machine details before ordering.

Q: Do I need new hardware to install it? A: Most installations reuse the existing radiator and fan fasteners, and checking bolt condition before you start helps avoid delays.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.