Fit for Kia Sorento Socket & Wire Taillight Bulb Holder 92480-C6000 2016-2018

Socket & Wire Taillight Bulb Holder for Kia Sorento

This Socket & Wire Taillight Bulb Holder for Kia Sorento replaces the OEM part number 92480-C6000 and restores secure bulb connection and power delivery in the taillight assembly. It is a direct fit for 2016 to 2018 Kia Sorento models, providing a reliable electrical connection for the brake, tail, and turn signal functions. This Socket & Wire Taillight Bulb Holder for Kia Sorento is the practical repair solution when the original socket becomes corroded, brittle, or fails to hold the bulb firmly.

Overview

This taillight bulb holder is an exact replacement for the factory socket and wire assembly in the 2016 to 2018 Kia Sorento. It carries the OEM cross-reference number 92480-C6000 and is engineered to restore proper electrical contact and secure bulb seating. The holder is intended for vehicle owners and technicians addressing intermittent rear lighting faults or a non-functional taillight.

Built For Performance

• Direct replacement for OEM part number 92480-C6000
• High-temperature resistant plastic housing withstands heat from the bulb
• Corrosion-resistant metal terminals maintain consistent electrical contact
• Pre-attached wire leads simplify installation and splicing
• Locking tab design holds the bulb firmly in place
• OEM-style connector for plug-and-play installation on compatible sockets

Fits These Machines

• for Kia Sorento 2016
• for Kia Sorento 2017
• for Kia Sorento 2018

On-The-Job Use

• Replacing a melted or broken bulb holder in the rear taillight housing
• Repairing intermittent brake or turn signal operation caused by loose socket contacts
• Restoring a secure connection for LED or standard incandescent bulbs
• Rebuilding a rear light assembly after an accident or moisture damage

Specs At A Glance

Good To Know

Q: Will this fit a 2017 Kia Sorento with a base halogen taillight? A: Yes, this is the standard bulb holder used in the 2016-2018 Sorento taillight assemblies and is compatible with the factory halogen bulb.

Q: Does this holder include the bulb? A: No, this is only the socket and wire assembly; the bulb is sold separately and must be purchased to complete the repair.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.