For 2007-2013 Nissan Altima Front Lower Control Arm Ball Joints Tie Rod Sway Bar

Front Suspension Kit for Nissan Altima

This front suspension kit delivers the lower control arm, ball joints, tie rod ends, and sway bar components needed to restore steering response and ride stability on 2007-2013 Nissan Altima models.

Overview

This front suspension kit for Nissan Altima bundles the lower control arm, ball joints, tie rod ends, and sway bar parts into one convenient set. It is designed for drivers and mechanics replacing worn front-end components on 2007-2013 Altima vehicles. Each piece in this front suspension kit for Nissan Altima is built to help bring back factory-style handling and alignment accuracy.

Built For Performance

• Lower control arm engineered to support proper suspension geometry under load
• Ball joints manufactured for smooth pivot action and reduced steering play
• Tie rod ends designed to translate steering input with minimal slack
• Sway bar components that help limit body roll during cornering
• Construction materials selected for resistance to road grime and corrosion
• Direct-fit design intended to match original mounting points

Fits These Machines

• for Nissan Altima 2007
• for Nissan Altima 2008
• for Nissan Altima 2009
• for Nissan Altima 2010
• for Nissan Altima 2011
• for Nissan Altima 2012
• for Nissan Altima 2013

On-The-Job Use

• Front-end rebuilds after steering looseness or clunking develops
• Alignment service where worn control arm and tie rod parts are replaced
• Routine suspension maintenance on higher-mileage Altima vehicles
• Collision repair involving front suspension components

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this kit? A: Yes, replacing control arm and tie rod components changes front-end geometry, so a professional alignment is recommended after installation.

Q: Can these parts be installed with basic hand tools? A: Most of the work can be done with standard hand tools, though a ball joint separator and torque wrench are commonly needed for a proper fit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.