For 2018-2022 Audi Rear Right Bumper Lower Tail Light Brake Stop Lamp 80A945070A

Rear Right Bumper Lower Tail Light Brake Stop Lamp for Audi

This rear right bumper lower tail light brake stop lamp, referenced as 80A945070A, is a direct-fit replacement lighting unit for the passenger side lower bumper position.

Overview

This rear right bumper lower tail light brake stop lamp is designed to restore the brake and tail lighting function on the lower right corner of the bumper. Manufactured to match the OEM layout, this tail light brake stop lamp uses the 80A945070A reference so buyers can cross-check it against their existing part. It suits Audi owners and collision repair shops needing a dependable lighting replacement without sourcing a complete bumper assembly.

Built For Performance

• Direct-fit replacement for the rear right lower bumper position
• Cross-references OEM part number 80A945070A for easy verification
• Combined brake, tail, and stop lamp function in one unit
• Housing designed to match the factory mounting points on the bumper
• Sealed lens construction helps resist moisture and road spray
• Wiring connector positioned to mate with the factory harness

Fits These Machines

• for Audi 2018-2022 models using the rear right lower bumper light position
• for Audi vehicles that accept OEM reference 80A945070A

On-The-Job Use

• Collision repair after a rear corner impact
• Restoring brake and tail light operation on the lower right bumper
• Replacing a cracked, fogged, or water-damaged lamp housing
• Body shop repairs where matching the OEM reference matters

Specs At A Glance

Good To Know

Q: How do I confirm this lamp fits my vehicle? A: Compare your existing lamp's part number against 80A945070A and verify the rear right lower bumper position. Serial number and trim level can affect fitment, so checking the original unit is the safest step.

Q: Is any wiring modification needed? A: This unit is built to connect with the factory harness and mounting points for its listed position. If the original connector or bracket differs, minor adaptation may be required.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.