For BMW Radiator Hose Retaining Spring Clip Clamp 0.87in 1.07in 1.83in U” shape

Radiator Hose Retaining Spring Clip for BMW

This U-shape radiator hose retaining spring clip for BMW secures coolant hoses at the thermostat housing, water pump, and radiator connections, with 0.87in, 1.07in, and 1.83in sizes covering common hose fitting diameters.

Overview

This radiator hose retaining spring clip for BMW locks coolant hoses onto their fittings using spring tension instead of screw-type clamps. The U-shape design slips over the hose end so the wire legs snap into the fitting groove and hold the hose against pressure and vibration. It suits DIY coolant repairs and shop maintenance on BMW cooling systems.

Built For Performance

• Spring steel construction holds clamping tension through heat cycles
• U-shape profile seats into hose fitting grooves for a positive lock
• Three listed sizes at 0.87in, 1.07in, and 1.83in cover common hose diameters
• Compact wire form keeps a low profile at tight housing connections
• Corrosion-resistant finish resists coolant splash and underhood moisture

On-The-Job Use

• Replacing lost or broken clips during coolant hose service
• Securing upper and lower radiator hoses after thermostat or water pump work
• Refreshing cooling system hardware during routine maintenance
• Keeping spare clips on hand for track day or roadside repairs

Specs At A Glance

Good To Know

Q: Do I need tools to install this clip? A: No, the spring clip presses on by hand and seats into the hose fitting groove. A small pick or flat screwdriver helps release it during removal.

Q: Will one clip fit every hose on my BMW? A: No, hose fittings vary in diameter, so match the clip size to the fitting you are securing. The three listed sizes cover the most common radiator hose connections.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.