For Cadillac Escalade Tahoe GMC Yukon 07-14 Power Steering Rack Pinion Assembly

Power Steering Rack and Pinion Assembly for Cadillac Escalade Tahoe GMC Yukon

This power steering rack and pinion assembly replaces the worn steering gear on 2007 to 2014 full-size GM SUVs and trucks, restoring precise steering response and eliminating play at the wheel.

Overview

This power steering rack and pinion assembly is a direct replacement steering gear for 2007 to 2014 Cadillac Escalade, Chevrolet Tahoe, and GMC Yukon models. The rack and pinion converts steering wheel input into lateral movement at the tie rods, giving the driver responsive control and reduced effort. It is built for owners and mechanics repairing loose, leaking, or binding steering on high-mileage SUVs.

Built For Performance

• Sealed hydraulic housing engineered to hold pressure and resist fluid leaks
• Precision-cut pinion gear teeth for smooth, low-play steering input
• Hardened rack shaft to resist wear under repeated steering cycles
• Pre-installed seals and boots to protect internal components from dust and moisture
• Mounting points machined to match factory chassis locations
• Pressure-tested before packing to confirm leak-free operation

Fits These Machines

• for Cadillac Escalade 2007-2014
• for Chevrolet Tahoe 2007-2014
• for GMC Yukon 2007-2014
• for Chevrolet Silverado 1500 2007-2014
• for GMC Sierra 1500 2007-2014

On-The-Job Use

• Replacing a leaking or worn steering rack on daily-driven SUVs
• Restoring steering feel on trucks used for towing and hauling
• Front-end repair after collision or curb impact damage
• Routine steering system overhaul on high-mileage vehicles

Specs At A Glance

Good To Know

Q: Does this rack and pinion come with tie rod ends? A: Tie rod ends are typically sold separately, so check your existing hardware or order them alongside this rack. Reusing worn outer tie rods can shorten the life of the new unit.

Q: Will I need a wheel alignment after installation? A: Yes, a front-end alignment is required after replacing a steering rack and pinion. Driving without one can cause uneven tire wear and off-center steering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.