For GY6 125cc 150cc Chinese 150 Scooter ATV Magneto Stator 8 Pole Coil 5 Wire

Magneto Stator for GY6 125cc 150cc Chinese Scooters and ATVs

This 8 pole magneto stator with a 5 wire coil is a replacement charging and ignition component for GY6 125cc and 150cc Chinese scooters and ATVs, delivering the AC signal the CDI and battery charging system depend on.

Overview

This 8 pole magneto stator is a direct-fit replacement for the stock ignition and charging coil on GY6 125cc and 150cc Chinese scooters and ATVs. It produces the electrical signal needed to fire the ignition and keep the battery topped up during normal riding. Riders and mechanics turn to this GY6 stator when the original coil fails, overheats, or loses output.

Built For Performance

• 8 pole coil configuration matched to GY6 125cc and 150cc charging systems
• 5 wire lead set for straightforward hookup to the CDI and regulator
• Laminated steel core wound with copper for consistent output
• Drop-in dimensional match for the factory stator position
• Insulated lead wires resist heat and vibration in the stator housing
• Compatible with common GY6 flywheel and magneto mounts

Fits These Machines

• for GY6 125cc Chinese scooters
• for GY6 150cc Chinese scooters
• for GY6 125cc Chinese ATVs
• for GY6 150cc Chinese ATVs
• for 150cc Chinese scooter and ATV models

On-The-Job Use

• Restoring spark and charging on a scooter with a failed stator
• Routine replacement during top-end or electrical repairs
• Workshop repair of ATVs used for trail and utility riding
• Rebuilds where a fresh charging coil is specified

Specs At A Glance

Good To Know

Q: How do I know if my stator needs replacing? A: A weak or no-spark condition, poor battery charging, or a visibly burnt coil usually points to a failed stator. Testing output with a multimeter against the service spec confirms it before you swap parts.

Q: Is the 5 wire stator the right match for my GY6? A: Most GY6 125cc and 150cc scooters and ATVs use an 8 pole, 5 wire stator, but wiring plugs and pin counts can vary by model. Compare your old stator's pole count and connector before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.