For Honda Accord 2018 2019 2020 1.5L 2.0L I4 2* Front Control Arms 2703-667981

Front Control Arms for Honda Accord

This pair of front control arms for Honda Accord 2018, 2019, and 2020 models with 1.5L or 2.0L I4 engines, referenced under 2703-667981, replaces worn lower arms to restore front suspension geometry and steering feel.

Overview

These front control arms for Honda Accord are direct-fit suspension components that connect the front knuckle to the subframe and locate the wheel through suspension travel. New arms with fresh bushings and ball joints help correct clunks, uneven tire wear, and vague steering caused by worn originals. They suit owners and shops refreshing the front end on 2018 through 2020 Accord models with 1.5L or 2.0L I4 powerplants.

Built For Performance

• Pair of front control arms covering both driver and passenger sides
• Pre-installed bushings for reduced road noise and tighter handling
• Integrated ball joints matched to the factory mounting points
• Steel construction built for daily driving loads
• OEM-style geometry that keeps alignment within factory range

Fits These Machines

• for Honda Accord 2018 1.5L I4
• for Honda Accord 2018 2.0L I4
• for Honda Accord 2019 1.5L I4
• for Honda Accord 2019 2.0L I4
• for Honda Accord 2020 1.5L I4
• for Honda Accord 2020 2.0L I4

On-The-Job Use

• Replacing arms with worn bushings that cause clunking over bumps
• Correcting steering wander and imprecise handling on older Accords
• Front end refresh alongside struts, tie rods, or ball joints
• Addressing uneven front tire wear traced to suspension play

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing control arms? A: Yes, replacing front control arms changes suspension geometry and an alignment should follow installation. Driving without one can cause uneven tire wear and handling issues.

Q: Can these arms be installed at home? A: Installation is possible with hand tools and a ball joint separator, though rusted hardware can make the job tough. A shop with a lift and alignment rack is the safer route for most owners.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.