For Honda Civic 06-11 Front LH RH Steering Knuckle & Wheel Hub Bearing Assembly

Front Steering Knuckle & Wheel Hub Bearing Assembly for Honda

This front steering knuckle and wheel hub bearing assembly is a direct-fit replacement unit for the 2006-2011 Honda Civic, combining the knuckle, hub, and bearing into one ready-to-install assembly.

Overview

This front steering knuckle and wheel hub bearing assembly restores proper steering geometry and wheel rotation on the 2006-2011 Honda Civic. Each unit pairs the steering knuckle with a pre-pressed wheel hub bearing, so the front LH or RH corner can be serviced as one assembly. It suits DIY installers and shops handling collision repair, bearing replacement, or suspension rebuilds.

Built For Performance

• Combines the steering knuckle, wheel hub, and bearing into a single pre-assembled unit
• Bearing is pre-pressed into the knuckle to cut installation time
• Durable cast construction designed for everyday street driving loads
• Mounting points machined to match the original front corner layout
• Sold for the front left or right position on the 2006-2011 Honda Civic

Fits These Machines

• for Honda Civic 2006
• for Honda Civic 2007
• for Honda Civic 2008
• for Honda Civic 2009
• for Honda Civic 2010
• for Honda Civic 2011

On-The-Job Use

• Replacing a worn or noisy front wheel bearing
• Collision repair after a front corner impact
• Front suspension and steering rebuilds
• Restoring proper wheel alignment geometry

Specs At A Glance

Good To Know

Q: Does this come with the bearing already installed? A: Yes, the wheel hub bearing is pre-pressed into the knuckle so the assembly bolts on as one unit.

Q: Is this sold as a pair? A: This listing is for a single front LH or RH assembly, so order two if you are servicing both sides.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.