For Hyundai Elantra Veloster Front Lower Control Arms w/ Ball Joints Tie Rod Kit

Front Lower Control Arms with Ball Joints and Tie Rod Kit for Hyundai Elantra and Veloster

This front lower control arm assembly with press-fit ball joints and matching tie rod kit replaces worn suspension components on Hyundai Elantra and Veloster models, restoring proper steering geometry and ride control.

Overview

This front suspension kit pairs lower control arms with ball joints and tie rods for Hyundai Elantra and Veloster. It renews the steering and suspension linkage so the vehicle tracks straight and absorbs road input correctly. A practical choice for DIY repairers and shops servicing front-end wear.

Built For Performance

• Formed steel control arms built to match factory mounting points
• Ball joints pressed in and ready for installation
• Corrosion-resistant coating on arms and studs
• Tie rod ends supplied with matching hardware
• Direct-fit geometry for the listed Hyundai applications

Fits These Machines

• for Hyundai Elantra
• for Hyundai Veloster

On-The-Job Use

• Replacing clunking or loose front suspension components
• Restoring steering response after bushing and joint wear
• Front-end rebuilds during alignment service
• Correcting uneven tire wear tied to worn linkage

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this kit? A: Yes, replacing control arms and tie rods changes suspension geometry, so a professional alignment is required afterward.

Q: Are the ball joints already installed in the arms? A: Yes, the ball joints come pressed into the control arms so the assembly bolts on without extra pressing work.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.