For LS Engine Motor Mounts LS Swap Kit LS Conversion Adapter Plates LS1 LS3 LS2

LS Engine Motor Mounts LS Swap Kit for LS Conversion

This LS swap motor mount and adapter plate kit positions LS series engines in engine-swap builds, using conversion adapter plates to mate LS1, LS3, and LS2 blocks to classic chassis mounting points.

Overview

This LS swap kit includes motor mounts and conversion adapter plates built to locate an LS series engine in a swap project. The adapter plates bolt to the block so standard chassis mounts line up, simplifying engine placement. It suits builders swapping an LS1, LS3, or LS2 into a project car or truck.

Built For Performance

• Adapter plates drilled to match common LS block mount bosses
• Steel construction built to handle engine torque loads
• Positions the engine for proper driveline alignment
• Works with common LS swap mount and bracket setups
• Bolt-on design that reduces fabrication during a swap

On-The-Job Use

• LS engine swaps into classic cars and trucks
• Project builds using LS1, LS2, or LS3 powerplants
• Shop conversions that need repeatable engine placement
• Drivetrain mock-up and alignment during a swap

Specs At A Glance

Good To Know

Q: Will these mounts fit any chassis? A: Adapter plates are made to suit common LS swap applications, but frame-side brackets and chassis-specific mounts vary, so measure your mounting points before ordering.

Q: Do I need to modify the block to install them? A: These plates bolt to existing LS block mount bosses, so no block modification is normally required, though some builds may need drilling or trimming on the chassis side.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.