For Pentair Master Temp 400 Control Board Kit w/472610Z Switch Pad 42002-0007S

Control Board Kit for Pentair Master Temp 400

This control board kit with 472610Z switch pad and 42002-0007S board restores reliable operation to Master Temp 400 pool heaters, replacing worn or failed control components with a matched set for consistent ignition and temperature control.

Overview

This control board kit for Pentair Master Temp 400 heaters pairs the 42002-0007S control board with the 472610Z switch pad for a complete replacement of the heater's control interface. The kit suits pool owners and service technicians repairing a Master Temp 400 that will not fire, hold temperature, or respond to the keypad. Each component is built to match the original fit and connector layout for a straightforward swap.

Built For Performance

• 42002-0007S control board matches the Master Temp 400 connection layout
• 472610Z switch pad provides responsive membrane keypad input
• Paired kit avoids mismatched board and pad combinations
• Direct-fit connectors reduce installation time
• Built to handle the heat and moisture of pool equipment pads

Fits These Machines

• for Pentair Master Temp 400 pool heater

On-The-Job Use

• Replacing a control board that fails to power the heater
• Restoring keypad response on a Master Temp 400
• Service calls where both the board and switch pad need renewal
• Seasonal maintenance before reopening a pool

Specs At A Glance

Good To Know

Q: Do I need both the board and the switch pad? A: The kit includes both, which is useful when the keypad and board are replaced together. Confirm your heater model and existing part numbers before ordering.

Q: Will this fit every Master Temp 400? A: Fit can vary by production run and serial number. Match the 42002-0007S and 472610Z numbers to your unit before purchase.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.