For Polaris RZR 4 800 EFI 2010-2014 32.5" Rear Suspension Stabilizer Sway Bar

Rear Suspension Stabilizer Sway Bar for Polaris RZR 4 800 EFI

This rear suspension stabilizer sway bar is a direct replacement component built for the Polaris RZR 4 800 EFI, designed to control body roll and keep the rear end planted through turns.

Overview

This rear suspension stabilizer sway bar fits Polaris RZR 4 800 EFI models from 2010 through 2014 and works to reduce rear chassis lean during cornering and off-camber terrain. The bar ties the rear suspension arms together so the machine stays flatter and more predictable under load. It is a practical replacement for a bent, worn, or missing factory sway bar on these four-seat side-by-sides.

Built For Performance

• Spring-steel construction resists flex fatigue under repeated suspension cycling
• 32.5 inch overall width sized for the RZR 4 800 EFI rear suspension layout
• Direct-fit geometry for the 2010 to 2014 model run
• Mounts using the factory sway bar location and hardware points
• Reduces rear body roll for more stable cornering
• Corrosion-resistant finish to withstand mud, water, and trail debris

Fits These Machines

• for Polaris RZR 4 800 EFI 2010
• for Polaris RZR 4 800 EFI 2011
• for Polaris RZR 4 800 EFI 2012
• for Polaris RZR 4 800 EFI 2013
• for Polaris RZR 4 800 EFI 2014

On-The-Job Use

• Trail riding where rear stability through ruts and turns matters
• Utility work with passengers and cargo in the rear seats
• Dune and desert running that loads the rear suspension hard
• Replacing a bent or broken factory sway bar after impact
• Restoring factory handling after suspension work

Specs At A Glance

Good To Know

Q: Will this bar work on a two-seat RZR 800? A: It is sized for the four-seat RZR 4 800 EFI platform, so confirm your exact model and year before ordering. Two-seat machines use a different rear width.

Q: Do I need new bushings or end links with this bar? A: It is sold as the bar itself, so inspect your existing bushings and end links and replace any that are cracked or worn. Reusing worn hardware can cause noise and reduce the bar's effect.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.