For Polaris Trail Boss 350L 4X4 2X4 Intake Manifold Carb Boot Kit 1990-1993

Intake Manifold Carb Boot Kit for Polaris

This intake manifold carb boot kit for Polaris Trail Boss 350L 4X4 and 2X4 models (1990 to 1993) is a complete connecting set between the carburetor and the intake manifold.

Overview

This intake manifold carb boot kit supplies the rubber mount units used on the Polaris Trail Boss 350L engine. The intake boot arrangement seals the carburetor outlet to the manifold and prevents air from passing around the flange. It is designed for the 350L 2X4 and 4X4 chassis from the 1990 to 1993 production area, fitting the stock rail surface.

Built For Performance

• Full boot kit supply for the carb bore and intake mount series
• Rubber collars that fit the original clamp tightness
• Molded to measure and align the carburetor body squarely with the intake port
• Stiffens the engine airway so the unit does not sag after installation
• Kit layout provides both carburetor connection points in one Pn

Fits These Machines

• for Polaris Trail Boss 350L 4X4 (1990 to 1993)
• for Polaris Trail Boss 350L 2X4 (1990 to 1993)

On-The-Job Use

• Replacing the intake carb boot while servicing the ATV carburetor
• Upper engine bolts when rebuilding the 350L intake system
• Performing a fuel or oscillator repair where the boot needs to be pulled loose
• Routine support for the Trail Boss quad by restoring the area around the carb

Specs At A Glance

Good To Know

Q: What is a common sign that the boot is in issue? A: A rough idle curve at the flare plays in: the engine hesitates until it eats the passing air of the worn boot in your?

Q: Do I need to remove the carb into piece tool will this install? A: The carb boot slides on with a simple clamp after the air box and the carb are removed from the rails.

Slight variation in finish or dimensions may occur between production runs, and the fit depends on serial, so confirm compatibility before ordering.