For Toyota Tundra 2004-2006 Sequoia 2004-2007 Front Lower Suspension Control Arm

Front Lower Suspension Control Arm for Toyota Tundra and Sequoia

This front lower suspension control arm is a direct-fit replacement for worn or damaged factory arms on 2004-2006 Toyota Tundra and 2004-2007 Toyota Sequoia models, restoring proper suspension geometry and steering response.

Overview

This front lower suspension control arm is built to replace a bent, rusted, or worn unit on your truck or SUV. The control arm for Toyota Tundra and Sequoia models connects the frame to the wheel hub, keeping alignment stable and handling predictable. It suits owners doing their own suspension repair or shops needing a dependable replacement arm.

Built For Performance

• Heavy-duty stamped steel construction for strength under load
• Pre-installed bushings for quicker installation
• Corrosion-resistant coating to extend service life
• Precisely formed to match factory mounting points
• Designed to hold alignment under daily driving and towing

Fits These Machines

• for Toyota Tundra 2004-2006
• for Toyota Sequoia 2004-2007

On-The-Job Use

• Replacing a bent arm after curb or pothole impact
• Restoring steering feel on high-mileage trucks
• Front-end rebuilds and alignment preparation
• Fleet and work truck suspension maintenance

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this control arm? A: Yes, an alignment is recommended after replacing a control arm to ensure correct camber and toe. Skipping it can cause uneven tire wear.

Q: Is this sold as a pair? A: This listing is for a single front lower control arm unless the title states otherwise. Check the quantity before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.