For Yamaha YZF R6 03-05 YZF R6S 06-09 Front Headlight+Upper Fairing Stay Bracket

Front Headlight and Upper Fairing Stay Bracket for Yamaha

This front headlight and upper fairing stay bracket for Yamaha brings the nose of your sportbike back to a clean, factory-style look while holding the headlight and fairing panels firmly at speed. Each upper fairing stay bracket for Yamaha is made to align with the original mounting points, so the headlight sits centered and the fairing gaps stay even. It is aimed at riders replacing crash-damaged front ends on first-generation and second-generation R6 models.

Overview

This front headlight and upper fairing stay bracket for Yamaha is a direct replacement assembly for worn or damaged original hardware on YZF R6 and R6S machines. The bracket carries the headlight housing and upper fairing panels at the correct angle, which keeps the front end rigid and the bodywork lined up. It suits riders rebuilding after a tip-over as well as anyone refreshing a track bike front end.

Built For Performance

• Combined headlight and upper fairing stay for Yamaha YZF R6 and R6S front end assembly
• Mounting points positioned to line up with the stock headlight and fairing attachment locations
• Rigid frame design resists flex so the fairing stays steady at highway and track speeds
• Steel construction suited to bolting up under normal torque without deforming
• Accepts the factory headlight connector layout for a straightforward swap
• Two-piece order covers the front headlight and the upper fairing stay bracket together

Fits These Machines

• for Yamaha YZF R6 2003
• for Yamaha YZF R6 2004
• for Yamaha YZF R6 2005
• for Yamaha YZF R6S 2006
• for Yamaha YZF R6S 2007
• for Yamaha YZF R6S 2008
• for Yamaha YZF R6S 2009

On-The-Job Use

• Repairing front end damage after a low-side or tip-over
• Rebuilding a track or race bike where fairing support must stay rigid
• Restoring a used R6 or R6S to clean street legal condition
• Refreshing an older fairing that no longer sits straight

Specs At A Glance

Good To Know

Q: Will this bracket line up with my existing fairing panels? A: It is made to use the original attachment points, so stock upper fairings and side panels should bolt on without redrilling. Test fit before tightening everything down.

Q: Do I need extra hardware to install it? A: The bracket mounts with the factory bolts from your old stay in most cases. Inspect the original fasteners and replace any that are stripped or rusted before fitting.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.