Front Brake Caliper For Can-Am Commander 800 800R 1000 1000R Maverick 1000

Front Brake Caliper for Can-Am Commander 800 800R 1000 1000R Maverick 1000

This front brake caliper is a replacement hydraulic brake component for Can-Am Commander 800, 800R, 1000, 1000R, and Maverick 1000 side-by-side models, squeezing the brake pads against the rotor to deliver reliable stopping power on the front wheel.

Overview

This front brake caliper is built as a direct replacement for the factory unit on Can-Am Commander and Maverick side-by-sides. It houses the brake pads and uses hydraulic pressure from the master cylinder to clamp the rotor, giving you dependable front braking for trail riding and utility work. It suits owners of Commander 800, 800R, 1000, 1000R, and Maverick 1000 machines replacing a leaking or seized caliper.

Built For Performance

• Hydraulic piston design provides consistent clamping force on the rotor
• Durable cast body stands up to heat cycles and trail debris
• Factory-style mounting points for straightforward bolt-on installation
• Bleeder fitting allows proper air removal during brake service
• Compatible with standard DOT brake fluid for the listed models

Fits These Machines

• for Can-Am Commander 800
• for Can-Am Commander 800R
• for Can-Am Commander 1000
• for Can-Am Commander 1000R
• for Can-Am Maverick 1000

On-The-Job Use

• Replacing a leaking or sticking caliper on trail side-by-sides
• Restoring front braking on utility machines used for hauling and towing
• Brake system refresh during routine maintenance
• Getting consistent stopping power back for steep descents

Specs At A Glance

Good To Know

Q: Do I need to bleed the brakes after installing this caliper? A: Yes, any time a caliper is replaced or the brake line is opened, air enters the system and must be bled out through the bleeder fitting. Use fresh DOT brake fluid and pump the lever until it feels firm.

Q: Is this an original Can-Am part? A: No, this is an aftermarket replacement caliper designed to fit the listed Commander and Maverick models. It mounts using the factory caliper location and hardware.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.