Front Control Arms Cam Bolts & Hardware Kit For 2002-09 Dodge Ram 1500 2500 3500

Front Control Arms Cam Bolts & Hardware Kit for Dodge Ram 1500 2500 3500

This front control arms cam bolts and hardware kit provides the alignment cams, bolts, and fasteners needed to restore proper front suspension geometry on 2002-2009 Dodge Ram 1500, 2500, and 3500 trucks.

Overview

This front control arms cam bolts and hardware kit supplies the cam bolts, washers, and nuts that secure the lower control arms and allow precise camber and caster adjustment on 2002-2009 Dodge Ram 1500, 2500, and 3500 models. The kit is built for owners and technicians replacing worn or seized front control arms cam bolts and hardware during alignment or suspension repair. Each piece is machined to match the original mounting points so the front end can be dialed back into spec.

Built For Performance

• Includes cam bolts, cam washers, and nuts required for front control arm mounting
• Heat-treated steel construction resists bending under suspension load
• Correct thread pitch and diameter for the 2002-2009 Dodge Ram front control arm mounts
• Cam plates allow fine camber and caster adjustment during alignment
• Corrosion-resistant coating helps withstand road salt and moisture
• Direct replacement for worn, stripped, or seized factory cam hardware

Fits These Machines

• for Dodge Ram 1500 (2002-2009)
• for Dodge Ram 2500 (2002-2009)
• for Dodge Ram 3500 (2002-2009)

On-The-Job Use

• Front end alignment after lift or leveling kit installation
• Control arm replacement and suspension rebuilds
• Correcting camber and caster on worn front suspensions
• Replacing seized or stripped factory cam bolts
• Routine front end service on high-mileage trucks

Specs At A Glance

Good To Know

Q: Do I need to replace cam bolts when replacing control arms? A: Yes, worn or seized cam bolts prevent proper alignment, so replacing them at the same time saves a second tear-down. Always have the front end aligned after installation.

Q: Can these cam bolts be reused? A: Factory cam bolts often seize or strip over time, so a fresh kit with proper hardware is the reliable choice. Torque to the manufacturer's spec during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.