Front Crossmember Subframe Bracket For Infiniti EX35 G35 G37 M35 544B2-EG300

Front Crossmember Subframe Bracket for Infiniti

This front crossmember subframe bracket is a replacement mounting component for Infiniti EX35, G35, G37, and M35 models, built to secure the subframe to the vehicle chassis with the correct geometry.

Overview

This front crossmember subframe bracket for Infiniti replaces a rusted, bent, or damaged factory mounting point and helps restore proper subframe alignment. The bracket is referenced under part number 544B2-EG300, making it easy to cross-check against a worn original before ordering. It suits owners and shops repairing front-end structural components on Infiniti EX35, G35, G37, and M35 vehicles.

Built For Performance

• Direct replacement design for the factory front crossmember mounting point
• Stamped steel construction for strength under suspension loads
• Bolt-on fitment using original mounting locations
• Cross-references OEM part number 544B2-EG300
• Built to hold subframe geometry within factory alignment specs

Fits These Machines

• for Infiniti EX35
• for Infiniti G35
• for Infiniti G37
• for Infiniti M35

On-The-Job Use

• Replacing a rusted or corroded front subframe bracket
• Collision repair after front-end impact damage
• Restoring subframe mounting points during suspension work
• Shop and DIY front-end structural repairs on Infiniti models

Specs At A Glance

Good To Know

Q: Is this bracket a genuine Infiniti part? A: No, it is an aftermarket replacement bracket that cross-references OEM part number 544B2-EG300, and it is not manufactured by Infiniti.

Q: Do I need an alignment after installing this bracket? A: Yes, replacing any subframe or crossmember mounting component can shift suspension geometry, so a professional alignment is recommended after installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.