Front CV Drive Shaft 5071.1A For 2012-2018 Jeep Wrangler JK 4WD NEW

Front CV Drive Shaft for Jeep

The Front CV Drive Shaft 5071.1A is a direct replacement front propeller shaft for 4WD Jeep Wrangler JK models covering 2012 through 2018, restoring the driveline connection between the transfer case and the front axle. It references OEM-style part 5071.1A for straightforward identification.

Overview

This Front CV Drive Shaft 5071.1A is the front driveline assembly that transfers torque from the transfer case to the front differential on 4WD models. Built for daily drivers and trail rigs, this CV drive shaft replacement keeps 4WD engagement smooth under load. It fits 2012-2018 Jeep Wrangler JK 4WD applications and is engineered to match the factory mounting points.

Built For Performance

• CV-style constant velocity joint at the transfer case end for smooth power transfer at steeper angles
• Balanced steel tube construction to reduce driveline vibration at highway speeds
• Precision-machined slip yoke and flange ends for a factory-style fit
• Sealed joint boots that keep grease in and trail debris out
• Direct bolt-on replacement requiring no driveline modification

Fits These Machines

• for Jeep Wrangler JK 4WD 2012
• for Jeep Wrangler JK 4WD 2013
• for Jeep Wrangler JK 4WD 2014
• for Jeep Wrangler JK 4WD 2015
• for Jeep Wrangler JK 4WD 2016
• for Jeep Wrangler JK 4WD 2017
• for Jeep Wrangler JK 4WD 2018

On-The-Job Use

• Replacing a worn or vibrating front shaft on a daily-driven JK
• Restoring 4WD engagement before a trail run or winter driving season
• Fixing clunking or binding felt through the floor under acceleration
• Servicing lifted Jeeps where the front driveline angle has changed

Specs At A Glance

Good To Know

Q: Do I need a lift kit to run this shaft? A: No, it is built as a direct replacement for the factory front shaft on 4WD Wrangler JK models. If your Jeep has a suspension lift, check the driveline angle before install.

Q: Should I replace the rear shaft at the same time? A: If the rear shaft shows the same vibration or joint wear, replacing both keeps the driveline balanced. Otherwise inspect the rear joints and replace only if needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.