Front Left And Right CV Joint Axles Fit for Polaris RZR XP 1000 Eps 2014-2019

Front Left And Right CV Joint Axles for Polaris RZR XP 1000 EPS

These front left and right CV joint axles are direct-fit drivetrain replacements built for Polaris RZR XP 1000 EPS side-by-sides, delivering power from the differential to the front wheels.

Overview

This pair of front CV joint axles for Polaris RZR XP 1000 EPS machines restores reliable power transfer to the front wheels on 2014-2019 models. Each axle assembly comes fully built with joints, boots, and hardware so you can bolt it in and get back on the trail. Riders who run their RZR XP 1000 EPS hard in mud, rocks, or sand will appreciate a fresh set of axles designed to handle real drivetrain loads.

Built For Performance

• Complete axle assembly with inner and outer CV joints already installed
• Heat-treated steel shafts for strength under drivetrain torque
• Heavy-duty rubber boots sealed against dirt, water, and grit
• Pre-packed with moly grease for smooth joint rotation
• Sold as a left and right pair for a full front axle refresh
• Direct-fit length and spline count for the listed RZR XP 1000 EPS models

Fits These Machines

• for Polaris RZR XP 1000 EPS 2014
• for Polaris RZR XP 1000 EPS 2015
• for Polaris RZR XP 1000 EPS 2016
• for Polaris RZR XP 1000 EPS 2017
• for Polaris RZR XP 1000 EPS 2018
• for Polaris RZR XP 1000 EPS 2019

On-The-Job Use

• Trail riding where rocks and ruts stress the front drivetrain
• Mud and water crossings that wear out boots and joints
• Sand dune runs requiring constant front-wheel drive engagement
• General farm, ranch, and property maintenance chores

Specs At A Glance

Good To Know

Q: Do I need to replace both front axles at the same time? A: It is not required, but replacing both sides together keeps wear even and avoids a second teardown soon after. If one side failed, the other often is not far behind.

Q: Are these ready to install out of the box? A: Yes, these axles come assembled with joints, boots, and grease already in place. You only need basic hand tools plus the correct torque specs for your machine.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.