Front Left Right Steering Knuckle and Wheel Hub Bearing for Honda Civic 06-11

Front Steering Knuckle and Wheel Hub Bearing for Honda Civic

This front left or right steering knuckle and wheel hub bearing assembly is a direct-fit suspension replacement part for 2006 through 2011 Honda Civic models needing renewed wheel mounting and steering support.

Overview

This front steering knuckle and wheel hub bearing for Honda Civic serves as the structural corner piece that holds the hub, bearing, and brake hardware in place. The integrated bearing lets the wheel rotate freely while the knuckle maintains steering and alignment angles. It suits 8th generation Civic owners and shops replacing worn front corner components.

Built For Performance

• Sturdy cast knuckle built to handle road shock and cornering loads
• Hub and bearing pre-installed for a faster front-end repair
• Precision-machined mounting bosses for accurate fitment
• Sealed bearing assembly shields against dirt and water intrusion
• Protective coating helps resist rust and road salt
• Sold for either front left or front right position

Fits These Machines

• for Honda Civic 2006
• for Honda Civic 2007
• for Honda Civic 2008
• for Honda Civic 2009
• for Honda Civic 2010
• for Honda Civic 2011

On-The-Job Use

• Front bearing and knuckle replacement on commuter Civics
• Repairing front suspension damage from potholes or minor impacts
• Restoring steering feel on high-mileage 8th generation Civics
• Brake and hub service where the knuckle is pulled for access

Specs At A Glance

Good To Know

Q: Can this be used on either the left or right side? A: This assembly is offered for the front left or right position depending on the listing option selected, so confirm the side needed before ordering. Verify the part number against your Civic's year and trim.

Q: Will the existing brake rotor and caliper bolt back on? A: The knuckle keeps factory mounting points for the brake hardware, so original components generally reinstall without modification. Inspect the rotor and pads while the corner is apart and replace as needed.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.