Front Left&Right Wheel Hub Bearing & Steering Knuckle For Honda Accord 2008-2012

Front Left and Right Wheel Hub Bearing and Steering Knuckle for Honda Accord

This front left and right wheel hub bearing and steering knuckle assembly fits 2008 to 2012 Honda Accord models, replacing the worn hub and knuckle with a single pre-assembled unit.

Overview

This front left and right wheel hub bearing and steering knuckle assembly is a direct replacement for the front corners of a 2008 to 2012 Honda Accord. It combines the hub bearing and knuckle into one assembly so you can swap the worn unit without pressing a bearing separately. It is aimed at owners and shops repairing collision damage or worn front wheel bearings.

Built For Performance

• Combines wheel hub bearing and steering knuckle in one assembly
• Sold as a pair for both front corners
• Pre-assembled for faster installation than pressing a bare bearing
• Designed to accept the factory brake and suspension mounting points
• Sealed bearing design keeps road debris out of the rolling elements

Fits These Machines

• for Honda Accord 2008
• for Honda Accord 2009
• for Honda Accord 2010
• for Honda Accord 2011
• for Honda Accord 2012

On-The-Job Use

• Replacing a noisy or rough front wheel bearing
• Collision repair after front-end impact
• Front brake and suspension service
• Restoring correct wheel alignment geometry

Specs At A Glance

Good To Know

Q: Do I need a press to install this? A: No press is needed for the bearing since it comes pre-assembled in the knuckle. You will still need standard hand tools for the axle nut and suspension fasteners.

Q: Will I need an alignment after installation? A: Yes, a front-end alignment is recommended after replacing the knuckle assembly. Camber and toe settings can shift when the new unit is bolted in.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.