Front LH Driver Lower Control Arm 51360-TVA-A04 For Honda Accord 18-21 2.0L 1.5L

Front LH Driver Lower Control Arm for Honda Accord

This front left lower control arm, OEM cross-reference 51360-TVA-A04, connects the driver-side front suspension to the subframe, maintaining wheel alignment and absorbing road forces on Accord models 2018 through 2021 with 1.5L and 2.0L engines.

Overview

This front left lower control arm for Honda Accord is a direct-fit suspension part built to restore the driver-side front corner after wear, impact, or corrosion. The arm pivots between the subframe and knuckle, guiding wheel travel while keeping steering response crisp and tire wear even. It is made for owners repairing 2018 to 2021 Accord sedans with either the 1.5L or 2.0L engine.

Built For Performance

• Stamped steel body matched to factory geometry
• Bushings pressed in to dampen road noise and vibration
• Ball joint provision for stable steering feedback
• OEM cross-reference 51360-TVA-A04 for direct fit
• Protective coating against rust and road salt
• Driver-side front position, LH designation

Fits These Machines

• for Honda Accord 2018 1.5L
• for Honda Accord 2019 1.5L
• for Honda Accord 2020 1.5L
• for Honda Accord 2021 1.5L
• for Honda Accord 2018 2.0L
• for Honda Accord 2019 2.0L
• for Honda Accord 2020 2.0L
• for Honda Accord 2021 2.0L

On-The-Job Use

• Replacing a bent driver-side arm after pothole damage
• Correcting alignment drift from worn bushings
• Front suspension refresh on high-mileage Accords
• Collision repair on the driver-side front corner
• Scheduled maintenance when ball joint play is detected

Specs At A Glance

Good To Know

Q: Will I need new fasteners for installation? A: Reusing original hardware is common, but inspecting bolts for stretch or corrosion before install is wise.

Q: Does this arm come with the ball joint already installed? A: Check the listing photos, since some assemblies include the ball joint and others require reusing the original unit.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.