Front LH+RH Steering Knuckle & Wheel Hub Bearing Fit for 2006- 2011 Honda Civic

Steering Knuckle & Wheel Hub Bearing for Honda Civic

This front left and right steering knuckle with integrated wheel hub bearing is a direct-fit assembly for 2006-2011 Honda Civic models, providing the pivot point for the front wheels and a mounting surface for the hub, bearing, and brake components.

Overview

This pair of front steering knuckles with wheel hub bearings is built for 2006-2011 Honda Civic owners who need to replace worn or damaged front suspension and wheel-end components. Each steering knuckle and wheel hub bearing assembly supports the wheel hub, allows the front wheels to steer, and provides mounting points for the brakes and struts. Sold as a left and right pair, this steering knuckle and wheel hub bearing set covers both sides of the front end in one order.

Built For Performance

• Includes both front left and front right steering knuckle assemblies in one pair
• Wheel hub bearing pre-installed in each knuckle for simplified installation
• Cast and machined to match the original mounting geometry for 2006-2011 Honda Civic
• Provides a solid mounting base for brake calipers, rotors, and strut assemblies
• Direct-fit replacement for worn, cracked, or impact-damaged factory knuckles

Fits These Machines

• for Honda Civic 2006
• for Honda Civic 2007
• for Honda Civic 2008
• for Honda Civic 2009
• for Honda Civic 2010
• for Honda Civic 2011

On-The-Job Use

• Replacing a knuckle damaged in a collision or curb strike
• Rebuilding front suspension and wheel-end components during a repair
• Fixing a failed or noisy wheel hub bearing on either front side
• Servicing brake or axle work that requires knuckle removal

Specs At A Glance

Good To Know

Q: Do I need any special tools to install this steering knuckle and wheel hub bearing pair? A: Standard hand tools plus a torque wrench and ball joint separator are typically used, and an alignment is recommended after installation. A: Confirm your Civic's trim and year match the listed fitment before ordering.

Q: Is the wheel hub bearing already pressed into the knuckle? A: Yes, the bearing is typically pre-installed in each knuckle so the assembly can bolt on, but always inspect the bearing and hardware before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.