Front LH Steering Knuckle for Dodge Challenger Charger Chrysler 300 2012-2021

Front LH Steering Knuckle for Dodge, Chrysler

This front left-hand steering knuckle is a suspension and steering component that mounts the wheel hub and connects to the strut, tie rod, and brake assembly on 2012-2021 Dodge Challenger, Dodge Charger, and Chrysler 300 models.

Overview

This front LH steering knuckle acts as the pivot point that joins the front suspension, steering, and braking systems on supported Chrysler and Dodge vehicles. Built as a direct-fit replacement, this front left steering knuckle helps restore proper alignment and steering response after the original part is worn or damaged. It suits drivers and technicians servicing 2012-2021 Challenger, Charger, and 300 models.

Built For Performance

• Cast construction built to withstand front-end steering and suspension loads
• Machined mounting points for the hub, strut, tie rod, and brake caliper
• Left-hand (driver side) front fitment
• Direct-fit design for supported 2012-2021 Chrysler and Dodge models
• Corrosion-resistant surface treatment for long service life

Fits These Machines

• for Dodge Challenger 2012-2021
• for Dodge Charger 2012-2021
• for Chrysler 300 2012-2021

On-The-Job Use

• Front left suspension rebuilds on supported Chrysler and Dodge cars
• Collision repair after driver-side front impact damage
• Replacing a worn or cracked left front knuckle causing alignment issues
• Routine steering and suspension service

Specs At A Glance

Good To Know

Q: Does this steering knuckle fit either side of the vehicle? A: This is a front left-hand steering knuckle, so it is intended for the driver side of supported models. Confirm your vehicle's required side before ordering.

Q: Is a wheel alignment needed after installing this steering knuckle? A: Yes, replacing a steering knuckle changes the front suspension geometry, so a professional alignment is recommended afterward. This helps ensure even tire wear and correct steering behavior.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.