Front RH Lower Control Arm 51350-TVA-A04 For Honda Accord 2018-2021 2.0L 1.5L

Front RH Lower Control Arm for Honda Accord

This front right lower control arm, OEM cross-reference 51350-TVA-A04, connects the front passenger-side suspension to the subframe, allowing controlled wheel travel while keeping alignment stable on Accord models with 1.5L and 2.0L engines.

Overview

This front right lower control arm for Honda Accord is a direct-fit suspension component engineered to restore proper handling geometry at the passenger-side front corner. The control arm pivots on the subframe and holds the knuckle in position, so it directly affects steering response, tire wear, and ride stability. It is intended for owners replacing a bent, worn, or rusted factory arm on 2018 through 2021 Accord sedans equipped with 1.5L or 2.0L engines.

Built For Performance

• Stamped steel construction matched to factory mounting points
• Pre-installed bushings absorb road vibration and reduce noise
• Ball joint seat machined for consistent steering feel
• OEM cross-reference 51350-TVA-A04 for direct replacement
• Corrosion-resistant finish for daily driver durability
• Passenger-side front position, RH designation

Fits These Machines

• for Honda Accord 2018 1.5L
• for Honda Accord 2019 1.5L
• for Honda Accord 2020 1.5L
• for Honda Accord 2021 1.5L
• for Honda Accord 2018 2.0L
• for Honda Accord 2019 2.0L
• for Honda Accord 2020 2.0L
• for Honda Accord 2021 2.0L

On-The-Job Use

• Replacing a bent arm after curb or pothole impact
• Restoring alignment after worn bushings cause uneven tire wear
• Front-end suspension rebuild on high-mileage Accords
• Collision repair on the passenger-side front corner
• Routine maintenance when the ball joint shows play

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this arm? A: Yes, a professional alignment is recommended after replacement since the arm controls camber and caster at the front corner.

Q: Is the ball joint included with this control arm? A: Confirm with the listing photos, as some assemblies ship with the ball joint pressed in and others require transferring the original.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.