Front Steering Knuckle for Dodge Challenger Charger Chrysler 12-21 Right Side

Front Steering Knuckle for Dodge Challenger Charger Chrysler Right Side

This front steering knuckle fits the right side of Dodge Challenger, Charger, and Chrysler 300 models from 2012 through 2021, acting as the hub carrier that joins the wheel bearing, strut, and steering linkage on the passenger side.

Overview

This front steering knuckle is the passenger-side hub carrier for compatible Dodge Challenger, Charger, and Chrysler 300 sedans built between 2012 and 2021. It holds the wheel hub and brake assembly while giving the strut and tie rod their mounting points, keeping the front wheel aligned and steerable. It suits drivers replacing a bent or worn knuckle after an impact or high-mileage service.

Built For Performance

• Robust cast construction for dependable load-bearing capacity
• Machined hub and caliper mounting surfaces for accurate brake fitment
• Formed steering arm for correct tie rod placement
• Protective finish to resist rust and road debris
• Factory-matched geometry for a direct bolt-on replacement

Fits These Machines

• for Dodge Challenger 2012-2021
• for Dodge Charger 2012-2021
• for Chrysler 300 2012-2021

On-The-Job Use

• Passenger-side front suspension repair after collision damage
• Replacing a fatigued or cracked factory knuckle
• Steering and alignment work requiring hub carrier removal
• Restoring proper wheel camber and caster on daily drivers

Specs At A Glance

Good To Know

Q: Is the wheel hub included with this front steering knuckle? A: No, the hub and bearing are separate, so you will typically reuse the existing units or install new ones during the job.

Q: Does this part fit both left and right sides? A: No, this knuckle is made for the right side only, and the driver side requires its own specific part.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.