Front Steering Knuckle w/ Wheel Hub Bearing Assembly for 2006 - 2011 Honda Civic

Front Steering Knuckle with Wheel Hub Bearing Assembly for Honda Civic

This front steering knuckle with wheel hub bearing assembly is a complete replacement unit for the 2006 through 2011 Honda Civic, combining the knuckle, hub, and bearing in one ready-to-install part.

Overview

This front steering knuckle with wheel hub bearing assembly restores proper steering geometry and wheel mounting for the 2006 through 2011 Honda Civic. The assembly pairs the steering knuckle with a pre-installed wheel hub bearing, so the suspension and steering pivot points are renewed in a single job. It suits DIYers and shops handling front-end repairs, wheel bearing noise, or collision damage.

Built For Performance

• Combines steering knuckle and wheel hub bearing in one assembly for fewer install steps
• Bearing pre-seated in the hub to reduce setup time during replacement
• Steel construction built to handle steering and suspension loads
• Direct-fit geometry for the listed Civic model years
• Helps eliminate wheel bearing noise and play when replacing worn units

Fits These Machines

• for Honda Civic 2006
• for Honda Civic 2007
• for Honda Civic 2008
• for Honda Civic 2009
• for Honda Civic 2010
• for Honda Civic 2011

On-The-Job Use

• Front wheel bearing replacement
• Steering and suspension rebuilds
• Collision repair on the front corner
• Routine front-end service

Specs At A Glance

Good To Know

Q: Does this assembly come with the bearing already installed? A: Yes, the wheel hub bearing is pressed into the assembly so it installs as one unit. Confirm your Civic year and trim before ordering.

Q: Is this sold as a pair? A: This listing covers one front steering knuckle with wheel hub bearing assembly. Check your vehicle's needs to decide if both sides are required.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.