Front Steering Knuckles & Wheel Hub Bearings for 2009 2010-2012 Honda Accord TSX

Front Steering Knuckles & Wheel Hub Bearings for Honda Accord and Acura TSX

These front steering knuckles with integrated wheel hub bearings are direct-fit suspension and drivetrain assemblies for 2009-2012 Honda Accord and Acura TSX models, restoring proper steering geometry and smooth wheel rotation.

Overview

These front steering knuckles and wheel hub bearings are complete corner assemblies that mount the front strut, brake components, and wheels while letting each front wheel spin on sealed bearings. Replacing worn knuckles and hub bearings restores correct steering geometry and eliminates the growl, play, or vibration that comes from failed front hub bearings. DIYers and shops servicing 2009-2012 Honda Accord or Acura TSX models will find these front steering knuckles and wheel hub bearings a practical bolt-on repair solution.

Built For Performance

• Cast steel knuckle body engineered to factory mounting geometry
• Pre-installed sealed wheel hub bearing for smooth, quiet rotation
• Machined strut and brake caliper mounting points for accurate alignment
• Corrosion-resistant finish on the knuckle casting
• Sold as a front pair for both sides of the vehicle

Fits These Machines

• for Honda Accord 2009
• for Honda Accord 2010
• for Honda Accord 2011
• for Honda Accord 2012
• for Acura TSX 2009
• for Acura TSX 2010
• for Acura TSX 2011
• for Acura TSX 2012

On-The-Job Use

• Replacing noisy or worn front wheel hub bearings
• Repairing front suspension after curb or collision damage
• Restoring factory steering feel on high-mileage Accords and TSXs
• Front-end rebuilds during brake or strut service

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing these knuckles? A: Yes, a front wheel alignment is required after replacing steering knuckles or hub bearings. Driving before alignment can cause uneven tire wear.

Q: Are the hub bearings already pressed into the knuckles? A: These assemblies come with the hub bearings pre-installed in the knuckles. That saves pressing work and reduces install time compared with separate bearings.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.