Headlight Lamp Actuator Control Relay Module For Corvette C4 1988-1996 NEW

Headlight Lamp Actuator Control Relay Module for Corvette C4

The headlight lamp actuator control relay module manages the pop-up headlight motors so the lamps raise and lower on command; a direct-fit replacement for the factory relay used across 1988-1996 C4 generation cars.

Overview

This headlight lamp actuator control relay module is a plug-in electronic unit that switches power to the headlight actuator motors on 1988-1996 Corvette C4 models. When the original relay fails, one or both headlights can stop rising, chatter, or stay stuck in position; this module restores normal open and close operation. It is aimed at C4 owners doing a straightforward relay replacement without rewiring the motor circuit.

Built For Performance

• Direct-fit replacement for the factory headlight actuator relay position
• Controls both left and right pop-up headlight motor circuits
• Sealed housing resists moisture and road splash in the front clip area
• Plug-in connector matches the factory harness without splicing
• Rated for repeated open and close cycles of the headlight doors

Fits These Machines

• for Chevrolet Corvette C4 1988
• for Chevrolet Corvette C4 1989
• for Chevrolet Corvette C4 1990
• for Chevrolet Corvette C4 1991
• for Chevrolet Corvette C4 1992
• for Chevrolet Corvette C4 1993
• for Chevrolet Corvette C4 1994
• for Chevrolet Corvette C4 1995
• for Chevrolet Corvette C4 1996

On-The-Job Use

• Replacing a failed headlight door relay on a C4 Corvette
• Restoring pop-up headlight function after moisture damage to the original unit
• Routine electrical refresh during front end service work
• Diagnosing headlight doors that open on one side only

Specs At A Glance

Good To Know

Q: Will this fix headlights that will not rise at all? A: If the actuators and wiring are intact but the relay has failed, replacing the module restores normal headlight door movement. Confirm the motors themselves still run before ordering.

Q: Do I need to modify the wiring to install it? A: No, this module is designed to plug into the factory connector in the headlight actuator circuit. Check your model year harness layout matches the original relay before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.