Heavy Duty Aluminum Poly Driveshaft Carrier Bearing For 58-1964 Chevy Impala

Heavy Duty Aluminum Poly Driveshaft Carrier Bearing for Chevy Impala

This heavy duty aluminum poly driveshaft carrier bearing supports the center of a two piece driveshaft, reducing vibration and keeping the shaft aligned, for 1958 through 1964 Chevy Impala models.

Overview

This heavy duty aluminum poly driveshaft carrier bearing is built for 1958 through 1964 Chevy Impala applications. It supports the midpoint of a two piece driveshaft and its poly construction helps absorb vibration while the aluminum housing keeps the assembly rigid. It is a practical replacement for worn factory carrier bearings on classic Impala builds.

Built For Performance

• Heavy duty aluminum housing for added rigidity
• Poly construction for vibration damping
• Carrier bearing design for two piece driveshaft support
• Built for 1958 through 1964 Chevy Impala applications

Fits These Machines

• for Chevy Impala 1958-1964

On-The-Job Use

• Classic Chevy Impala restoration projects
• Replacing a worn or noisy factory carrier bearing
• Two piece driveshaft service and repair
• Vibration reduction on street driven classics

Specs At A Glance

Good To Know

Q: What does a driveshaft carrier bearing do? A: It supports the center joint of a two piece driveshaft and keeps the shaft aligned, which helps control vibration and noise.

Q: Will this fit my Impala driveshaft? A: It is listed for 1958 through 1964 Chevy Impala applications, so confirm your driveshaft and mounting setup before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.