Heavy Duty Left&Right Air Front Shocks Absorbers For Polaris RZR 800 S 2009-2014

Front Air Shocks Absorbers for Polaris RZR 800 S

This pair of heavy duty left and right front air shocks absorbers is built to replace tired original units on the Polaris RZR 800 S, restoring controlled suspension travel and ride height for trail and dune riding.

Overview

These heavy duty front air shocks absorbers for Polaris RZR 800 S deliver a direct-fit suspension solution for riders who want predictable handling back on their side-by-side. Each front air shock absorber in this left and right pair is valved for the RZR 800 S chassis, helping soak up bumps and hold ride height under load. The set suits owners doing their own replacement work on a 2009 through 2014 machine.

Built For Performance

• Heavy duty construction engineered for the load and travel demands of the RZR 800 S front end
• Air spring design allows ride height and firmness adjustment through air pressure
• Sold as a matched left and right pair for balanced front suspension behavior
• Direct replacement mounting points for straightforward bolt-on installation
• Sealed air chamber built to resist pressure loss and debris intrusion on the trail
• Corrosion-resistant finish suited to mud, water crossings, and dusty conditions

Fits These Machines

• for Polaris RZR 800 S 2009
• for Polaris RZR 800 S 2010
• for Polaris RZR 800 S 2011
• for Polaris RZR 800 S 2012
• for Polaris RZR 800 S 2013
• for Polaris RZR 800 S 2014

On-The-Job Use

• Replacing blown or leaking front air shocks on a trail-driven RZR 800 S
• Restoring front ride height before a dune or desert trip
• Refreshing suspension on a used machine before resale
• Routine front end maintenance on a high-mileage side-by-side

Specs At A Glance

Good To Know

Q: Do I need to add air pressure after installing these front air shocks absorbers? A: Yes, these are air spring units, so set pressure with a suitable pump to reach your preferred ride height and firmness. Start low and adjust in small increments.

Q: Can I install this pair with basic hand tools? A: The mounting points match the factory front locations, so standard hand tools are generally enough. A torque wrench and a proper lift or jack stands make the job safer.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.