Highway Engine Guard Crash Bar Fit For Harley Touring Road King Street Glide 09+

Highway Engine Guard Crash Bar for Harley Touring

This highway engine guard crash bar is a bolt-on protection accessory that shields the lower engine, frame downtubes, and forward controls on Harley Touring models from road debris and tip-over contact.

Overview

This highway engine guard crash bar is built to absorb impact and guard the front frame area of Harley Touring motorcycles. Riders who log long highway miles or ride in dense traffic use this engine guard crash bar to protect the engine case and controls while adding a spot for highway pegs. It fits Road King and Street Glide models from 2009 onward.

Built For Performance

• Heavy-gauge tubular steel construction resists bending under impact
• Wide U-bend geometry protects the engine case and frame downtubes
• Pre-drilled mounting points accept highway pegs and footrests
• Powder-coat finish fights rust and road salt exposure
• Bolt-on installation using factory frame mounting locations

Fits These Machines

• for Harley Touring models 2009 and newer
• for Harley Road King
• for Harley Street Glide
• for Harley Road Glide

On-The-Job Use

• Long-distance highway touring
• Daily commuting in stop-and-go traffic
• Parking lot and low-speed maneuvering
• Two-up riding with luggage loaded

Specs At A Glance

Good To Know

Q: Does this bar work with factory highway pegs? A: Yes, the clamping area along the forward loop accepts most standard highway peg mounts. Confirm your peg clamp diameter before ordering.

Q: Will this clear the stock exhaust and floorboards? A: It is shaped for Harley Touring models and routes around the stock floorboard and exhaust positions. Check clearance on modified bikes before installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.