IGNITION COIL FOR WACKER WM80 0049598 49598 0103302 BS45Y BS52Y BS60Y BS65Y

Ignition Coil for Wacker

This ignition coil for Wacker WM80 and BS-series concrete vibrators replaces OEM cross-reference numbers 0049598, 49598, and 0103302 and delivers reliable spark for Wacker equipment.

Overview

This ignition coil for Wacker is a direct replacement for WM80 and BS45Y, BS52Y, BS60Y, and BS65Y models. It generates a high-voltage spark to fire the spark plug consistently, ensuring smooth engine operation. The ignition coil for Wacker features a solid epoxy resin casing for vibration resistance.

Built For Performance

• High-output secondary winding provides strong spark even at low RPM
• Allows consistent ignition timing for reliable startups
• Epoxy-encapsulated construction protects against moisture and shock
• Direct bolt-on replacement using factory mounting points
• Tested to match OEM coil resistance and spark output

Fits These Machines

• for Wacker WM80
• for Wacker BS45Y
• for Wacker BS52Y
• for Wacker BS60Y
• for Wacker BS65Y

On-The-Job Use

• Replacing a faulty ignition coil that causes intermittent spark or no-start
• Restoring performance on concrete vibrators used on construction sites
• Servicing Wacker compaction and vibration equipment in rental fleets
• Eliminating misfires during prolonged operation in dusty environments

Specs At A Glance

Good To Know

Q: Does this ignition coil include a spark plug or wire? A: No, this is just the coil; the spark plug and high-tension wire are not included and must be ordered separately if needed.

Q: Can I test the coil before installation? A: Use a multimeter to measure primary and secondary resistance values; typical primary resistance is 0.5–1.5 ohms and secondary is 5–10 k ohms for this type of coil.

Slight variation in finish or dimensions may occur between production runs, and confirm compatibility before ordering.