Injector Sleeve Cup Remover Installer Tool Set for CAT 3406E C10/12/15 9U-6891

Injector Sleeve Cup Remover and Installer Tool Set for CAT

This injector sleeve cup remover and installer tool set is designed to remove and seat injector sleeves on CAT 3406E and C10, C12, and C15 engines, cross-referencing 9U-6891.

Overview

This injector sleeve cup remover and installer tool set allows technicians to pull worn injector sleeves and press new ones into place on CAT 3406E and C10, C12, and C15 engines. It covers both removal and installation in one kit, cross-referencing 9U-6891. A practical addition for diesel mechanics handling top-end service on these engine platforms.

Built For Performance

• Combined remover and installer design covers both stages of sleeve service
• Cross-references OEM tool number 9U-6891
• Built for use on CAT 3406E and C10, C12, and C15 engines
• Constructed from durable steel for repeated shop use
• Designed to seat sleeves squarely for a proper seal
• Kit format keeps the needed pieces together for the job

Fits These Machines

• for CAT 3406E
• for CAT C10
• for CAT C12
• for CAT C15

On-The-Job Use

• Removing worn or leaking injector sleeves during top-end service
• Installing new injector sleeves to restore a proper coolant seal
• Diesel shop work on CAT 3406E and C10, C12, and C15 engines
• Preventing coolant contamination of the fuel system caused by failed sleeves

Specs At A Glance

Good To Know

Q: Does this set handle both removal and installation of injector sleeves? A: Yes, the kit is built to both pull the old sleeve and press the new one into place on supported CAT engines.

Q: Is this an OEM CAT tool? A: No, this is an aftermarket tool set that cross-references OEM number 9U-6891 for fit and function reference.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.