Intake Exhaust Valves For 2007-2017 Chevrolet GM Buick Saturn 2.0 2.4L Engine

Intake Exhaust Valves for Chevrolet GM Buick Saturn

These intake exhaust valves are replacement engine valvetrain components for 2.0L and 2.4L applications, controlling air and fuel flow into the combustion chamber and exhaust gases out through the cylinder head.

Overview

This intake exhaust valve set is a direct-fit replacement for worn or burnt valves in 2.0L and 2.4L GM engines. Each valve is built to restore proper cylinder sealing and compression on Chevrolet, Buick, and Saturn vehicles. Engine builders and DIY mechanics working on these four-cylinder platforms will find this set a practical solution for top-end rebuilds.

Built For Performance

• Constructed from heat-resistant alloy steel for durability in high-temperature combustion environments
• Precision-machined stem diameters for smooth guide fit and consistent valve actuation
• Face and margin ground to support proper sealing against the valve seat
• Intake and exhaust pieces supplied as a matched set for complete cylinder head service
• Designed to meet original equipment dimensions for drop-in replacement

Fits These Machines

• for Chevrolet vehicles equipped with 2.0L and 2.4L engines (2007-2017)
• for GM vehicles equipped with 2.0L and 2.4L engines (2007-2017)
• for Buick vehicles equipped with 2.0L and 2.4L engines (2007-2017)
• for Saturn vehicles equipped with 2.0L and 2.4L engines (2007-2017)

On-The-Job Use

• Cylinder head rebuilds and valve jobs on 2.0L and 2.4L four-cylinder engines
• Replacing burnt or bent valves after timing chain or interference failures
• Top-end engine refresh during head gasket replacement work
• Restoring compression on high-mileage Chevrolet, Buick, and Saturn vehicles

Specs At A Glance

Good To Know

Q: Should valves be replaced in complete sets? A: Replacing all intake and exhaust valves together is recommended when servicing a cylinder head, since mixing worn and new pieces can affect sealing and compression.

Q: Is machining required during installation? A: Valve seats and guides should be inspected and machined as needed before installation to ensure proper sealing and stem clearance.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.