Intake Manifold Assembly for Mercedes-Benz C280 E350 CLK350 GLK350 SLK350 ML350

Intake Manifold Assembly for Mercedes-Benz

This intake manifold assembly delivers air to each cylinder for Mercedes-Benz C280, E350, CLK350, GLK350, SLK350, and ML350 models.

Overview

This intake manifold assembly is the air distribution unit that feeds the engine cylinders on Mercedes-Benz C280, E350, CLK350, GLK350, SLK350, and ML350 applications. It routes incoming air from the throttle body into the cylinder head ports so combustion stays even across the bank. A solid choice for owners replacing a cracked or warped intake manifold assembly.

Built For Performance

• One-piece molded body designed to match the factory port spacing for the listed Mercedes-Benz applications
• Rugged composite construction resistant to heat cycling and engine bay vibration
• Integrated runner geometry tuned for smooth airflow across the cylinder bank
• Preformed mounting flanges for a stable seal at the cylinder head
• Direct fitment for the listed 3.5L V6 models without custom modification

Fits These Machines

• for Mercedes-Benz C280
• for Mercedes-Benz E350
• for Mercedes-Benz CLK350
• for Mercedes-Benz GLK350
• for Mercedes-Benz SLK350
• for Mercedes-Benz ML350

On-The-Job Use

• Routine replacement after a cracked or leaking intake manifold is found
• Engine rebuilds where the original manifold has warped or damaged ports
• Restoring proper idle and air-fuel balance on higher mileage V6 engines
• Addressing rough running or lean codes traced to manifold leaks

Specs At A Glance

Good To Know

Q: Does this intake manifold assembly replace the original on my Mercedes-Benz without modification? A: It is built to match the factory mounting points and port layout for the listed models, so it installs like the original. Confirm your engine and model year before ordering.

Q: Are gaskets included with this intake manifold assembly? A: Gaskets and hardware are not always included, so check your rebuild kit or order new gaskets separately if needed. Reusing old gaskets is not recommended during installation.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.