Intake Manifold Carburetor Boot for Polaris Trail Blazer 250 1990-2006

Intake Manifold Carburetor Boot for Polaris

The Intake Manifold Carburetor Boot for Polaris connects the carburetor to the cylinder on Polaris Trail Blazer 250 ATVs from 1990 to 2006.

Overview

The Intake Manifold Carburetor Boot for Polaris is a rubber boot that goes between the carburetor and the cylinder on the Polaris Trail Blazer 250. It keeps the air and fuel mixture sealed from the outside. This intake manifold boot for Polaris is the right part when the old boot is cracked and let in unmetered air.

Built For Performance

• Direct fit for Polaris Trail Blazer 250 from 1990 to 2006
• Seals the carburetor opening to prevent vacuum leaks
• Stable under engine heat
• Maintains the correct port angle
• Refreshes the intake assembly after the old boot wears

Fits These Machines

• for Polaris Trail Blazer 250 (1990-2006)

On-The-Job Use

• For a split or cracked boot that causes a rough or leaky condition
• During carburetor service or intake manifold repair
• When a worn seal makes the ATV hard to tune

Specs At A Glance

Good To Know

Q: What are signs this boot needs replacement?A: If you hear a hiss from the intake or the engine stalls at an idle, the gord boot may be leaking and should be swapped.

Q: Is the boot easy to install?A: It turns over the carburetor lip and the cylinder flange; with the clamp screw backed off it pulls out and fits on.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.