LS 92MM Throttle Body with Position Sensors TPS IAC & Throttle Gas Cable Kit

92mm Throttle Body with Position Sensors for LS Engines

This 92mm throttle body with position sensors, TPS, IAC, and throttle gas cable kit is a direct-fit air intake component that regulates airflow into LS-series engines for improved throttle response and consistent idle control.

Overview

This 92mm throttle body assembly delivers the airflow and sensor integration needed for LS engine builds. The included throttle position sensor, idle air control, and gas cable kit make it a complete bolt-on solution for enthusiasts and builders. Each unit is designed to work with the 92mm throttle body specifications common to LS platforms.

Built For Performance

• 92mm bore for increased airflow over stock throttle bodies
• Integrated throttle position sensor for accurate pedal signal
• Idle air control valve included for stable idle management
• Throttle gas cable kit included for mechanical linkage setups
• Durable aluminum housing built to withstand engine bay heat
• Direct-fit design for LS-series intake manifolds

On-The-Job Use

• Engine swaps and performance builds requiring larger throttle bodies
• Replacement of worn or faulty factory LS throttle bodies
• Street and strip applications needing reliable airflow

Specs At A Glance

Good To Know

Q: Does this throttle body require tuning after installation? A: Yes, a recalibration or tune is typically recommended so the ECU reads the new sensor values correctly. A: This applies whether you are replacing a factory unit or adding it during a swap.

Q: Are the sensors pre-installed? A: The throttle position sensor and idle air control are included in the kit, though final calibration may be needed. A: Follow your engine management guidelines during setup.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.