New assenger Inner Tail Light Brake Lamp Right 4PIN For 21-23 Tesla Model 3 / Y
New assenger Inner Tail Light Brake Lamp Right 4PIN For 21-23 Tesla Model 3 / Y
Couldn't load pickup availability
Passenger Inner Tail Light Brake Lamp for Tesla Model 3 and Model Y
This passenger inner tail light brake lamp is a direct replacement for the right-side inner trunk-mounted lamp on 2021 through 2023 Tesla Model 3 and Model Y vehicles, featuring a 4-pin connector for straightforward plug-in installation.
Overview
This passenger inner tail light brake lamp restores proper rear lighting on your Tesla Model 3 or Model Y after a cracked or failed lens. The 4-pin connector matches the factory harness, so the tail light brake lamp installs without splicing or adapter wiring. It is a practical replacement for drivers who want a clean, functional rear lamp without paying dealership prices.
Built For Performance
- 4-pin connector matches the factory plug on 2021-2023 Model 3 and Model Y
- Right-side inner trunk-mounted position for correct fitment
- Red lens housing provides proper brake and tail light visibility
- Sealed housing design helps resist moisture intrusion
- Direct bolt-in replacement for the original inner lamp
Fits These Machines
- for Tesla Model 3 2021-2023
- for Tesla Model Y 2021-2023
On-The-Job Use
- Replacing a cracked or fogged inner tail lamp after a rear impact
- Restoring factory brake light function before a safety inspection
- Fixing a lamp that has water intrusion or a failed LED board
- Repairing rear lighting after a minor trunk lid collision
Specs At A Glance
| Position | Passenger side, inner |
| Connector | 4-pin |
| Function | Brake and tail light |
| Fitment Years | 2021-2023 |
Good To Know
Q: Will this fit both Model 3 and Model Y? A: Yes, this inner tail lamp is listed for 2021-2023 Model 3 and Model Y applications with the 4-pin connector. Confirm your vehicle's connector type and side before ordering.
Q: Is any coding or programming required? A: No coding is typically needed since this lamp uses the factory 4-pin plug. Simply remove the old unit and connect the new one.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
