New Black Rear Grab Bar Bumper Grab Bar Steel For Yamaha Banshee 350 1987-2006

Rear Grab Bar Bumper for Yamaha Banshee 350

This black steel rear grab bar bumper mounts to the back of the Yamaha Banshee 350 and gives riders a solid handhold plus rear protection. It is a direct-fit replacement for the factory grab bar on 1987-2006 models. Built from steel and finished in black, it stands up to trail use and repeated handling.

Overview

This rear grab bar bumper is designed for the Yamaha Banshee 350 from 1987 through 2006 and replaces the factory rear grab bar. It provides a strong handhold for lifting and maneuvering the quad while shielding the rear of the machine from impact. Riders rebuilding a Banshee 350 or replacing a bent stock bar will find it a straightforward bolt-on part.

Built For Performance

• Steel construction for strength under load and impact
• Black finish that resists corrosion and blends with factory plastics
• Bent to match the factory rear grab bar profile for the Banshee 350
• Mounting points positioned for direct fit to the stock rear frame location
• Rounded grab section that gives a secure grip when lifting the rear end
• Rear protection that helps guard the seat and fender area from tip-overs

Fits These Machines

• for Yamaha Banshee 350 (1987-2006)

On-The-Job Use

• Trail and dune riding where a rear handhold helps with recovery and repositioning
• Track and drag use where the rear grab bar protects the tail section
• Lifting and moving the quad in the garage or on a trailer
• Rebuilds and restorations that need a factory-style rear grab bar

Specs At A Glance

Good To Know

Q: Does this grab bar require drilling or modification to install? A: It is built to bolt to the factory rear mounting points on the Banshee 350, so no drilling is normally needed. Confirm your frame's mounting holes match the stock layout before installing.

Q: Will it work with aftermarket rear plastics or a widened axle? A: Fit can change when aftermarket plastics, grab bar extensions, or a widened rear end are installed. Test-fit the bar before fully tightening the mounting hardware.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.