New Braided Dual Feed Carb Fuel Line Fitting 8AN For Holley 4150 Carburetor AN8

Braided Dual Feed Carb Fuel Line Fitting 8AN for Holley 4150 Carburetor

This dual feed carb fuel line fitting is an 8AN braided line kit built to route fuel to a Holley 4150 carburetor, replacing the stock hard line with a flexible, high-flow connection.

Overview

This braided dual feed carb fuel line fitting delivers fuel to both bowls of a Holley 4150 carburetor through a single 8AN feed line. The braided dual feed carb fuel line fitting is a common choice for builders plumbing a Holley 4150 on a performance engine. It replaces the factory hard line with a flexible braided assembly that handles vibration and routing angles more easily.

Built For Performance

• 8AN inlet size for high-flow fuel delivery
• Braided outer construction resists abrasion and vibration
• Dual feed design routes fuel to both float bowls
• Fittings sized for Holley 4150 carburetor inlet threads
• Flexible line simplifies routing in tight engine bays

Fits These Machines

• for Holley 4150 carburetor

On-The-Job Use

• Plumbing a dual feed fuel system on a Holley 4150 carburetor
• Carbureted V8 builds and engine swaps
• Replacing a worn or restrictive factory fuel line
• Race car and street rod fuel system assembly

Specs At A Glance

Good To Know

Q: Will this line fit a Holley 4150 without adapters? A: It is sized for the Holley 4150 carburetor inlet and 8AN fuel feed, so confirm your bowl fittings match 8AN before ordering.

Q: Can I use this with a fuel pressure regulator? A: Yes, a dual feed line of this type is commonly run with a regulator feeding a Holley 4150, as long as the plumbing matches 8AN.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.