New For 2011-17 Honda Odyssey Front Lower Control Arm Tie Rod End Suspension Kit

Front Lower Control Arm Tie Rod End Suspension Kit for Honda Odyssey

This front lower control arm and tie rod end suspension kit restores steering response and ride stability on 2011-2017 Honda Odyssey models with worn or damaged front end components.

Overview

This front lower control arm tie rod end suspension kit is a direct-fit replacement set for 2011-2017 Honda Odyssey models. The kit combines lower control arms with tie rod ends to address the bushings, ball joints, and steering linkage that wear over time. It is intended for owners and shops refreshing the front suspension of a daily-driven or high-mileage Odyssey.

Built For Performance

• Front lower control arm assembly with pressed-in ball joint for direct installation
• Tie rod ends with threaded studs sized to the original steering linkage
• Rubber bushings formulated to damp road vibration and hold alignment
• Forged or cast steel construction for load-bearing strength
• Coated finish to resist corrosion from road salt and moisture
• Complete side-specific hardware for straightforward replacement

Fits These Machines

• for Honda Odyssey 2011
• for Honda Odyssey 2012
• for Honda Odyssey 2013
• for Honda Odyssey 2014
• for Honda Odyssey 2015
• for Honda Odyssey 2016
• for Honda Odyssey 2017

On-The-Job Use

• Replacing clunking or loose front lower control arms
• Correcting steering wander and vague on-center feel
• Refreshing front suspension during alignment service
• Restoring ride quality on high-mileage minivans
• Routine front end rebuilds in a shop setting

Specs At A Glance

Good To Know

Q: Do I need an alignment after installing this kit? A: Yes, replacing control arms and tie rod ends changes suspension geometry, so a professional alignment is required afterward.

Q: Is this sold as a single side or a pair? A: Confirm the quantity and side coverage in the listing photos and description before ordering, since front kits vary by listing.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.