New For GM Turbine Stator Shaft Teflon Seal Installer/Resizer Transmission Tool

Turbine Stator Shaft Teflon Seal Installer and Resizer for GM Transmissions

This turbine stator shaft Teflon seal installer and resizer is a transmission service tool made for GM units, sized to seat and size the Teflon seals that ride on the stator shaft.

Overview

This Teflon seal installer and resizer is a specialty transmission tool for GM turbine stator shafts. It presses the Teflon seal onto the shaft and resizes it to the correct diameter so the seal seats properly during a rebuild. It is made for transmission technicians and rebuilders working on GM automatic transmissions.

Built For Performance

• Sizing sleeve resizes Teflon seals to the correct installed diameter
• Installer body slides seals onto the stator shaft without nicking the seal lip
• Tool geometry matches the GM stator shaft seal seat for a controlled fit
• Steel construction holds its shape through repeated shop use
• Compact design stores easily in a transmission tool drawer

Fits These Machines

• for GM automatic transmissions using a turbine stator shaft Teflon seal
• for GM transmission rebuilds that require seal sizing after installation

On-The-Job Use

• Rebuilding GM automatic transmissions in a repair shop
• Replacing worn or damaged stator shaft Teflon seals during a teardown
• Sizing new seals before the stator shaft goes back into the case

Specs At A Glance

Good To Know

Q: Can I install the seal without the resizer? A: Teflon seals need to be sized after installation so they sit at the right diameter on the shaft. Using the resizer as part of the install helps the seal seat correctly.

Q: Will this fit every GM transmission? A: Fit depends on the specific transmission model and stator shaft design. Confirm your transmission model and shaft dimensions against the listing before ordering.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.