Oil Seal for Kubota MX4800DT MX4800H MX5000DT MX5100DT MX5100H MX5200DT Tractor

Oil Seal for Kubota MX4800DT MX4800H MX5000DT MX5100DT MX5100H MX5200DT Tractor

This oil seal for Kubota MX4800DT, MX4800H, MX5000DT, MX5100DT, MX5100H, and MX5200DT tractors is a replacement component that prevents lubricant leakage and keeps contaminants out of rotating shafts and housings. It is designed to maintain proper oil retention in critical tractor systems, supporting long service life and reliable operation.

Overview

This oil seal for Kubota MX-Series tractors is a direct-fit sealing component that helps maintain proper lubrication by blocking dirt, dust, and moisture from entering bearing and shaft areas. It is intended for owners and technicians servicing these specific Kubota tractor models, where a worn or damaged seal can lead to oil loss and premature component wear. This oil seal for Kubota machines provides a dependable replacement to restore sealing integrity in demanding agricultural work.

Built For Performance

• Constructed from durable rubber and metal materials to withstand rotational friction and pressure
• Precision-molded sealing lip for consistent contact with the shaft surface
• Designed to resist common agricultural fluids, including oils and greases
• Engineered to fit standard bore and shaft dimensions for the listed Kubota models
• Helps prevent contamination ingress that can shorten bearing and gear life
• Reinforced outer casing for secure press-fit installation

Fits These Machines

• for Kubota MX4800DT
• for Kubota MX4800H
• for Kubota MX5000DT
• for Kubota MX5100DT
• for Kubota MX5100H
• for Kubota MX5200DT

On-The-Job Use

• Used during transmission or axle service to replace worn sealing rings
• Commonly applied in routine maintenance on compact and utility tractors
• Supports proper lubrication in front axle, final drive, or PTO housings
• Used in repair shops or by owner-operators when rebuilding shaft assemblies

Specs At A Glance

Good To Know

Q: What causes an axle oil seal to fail on a Kubota tractor? A: Common causes include shaft wear, debris scoring the sealing lip, or age-related rubber hardening. Replacing the seal promptly prevents oil loss and prevents dirt from damaging bearings or gears.

Q: Should I replace the seal on both sides of the axle at the same time? A: It is often advisable to replace seals on both sides during a major service, as wear tends to occur evenly. This can save labor time and reduce the chance of a second failure shortly after the first repair.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.