Pair 425mm 16.75" Front Air Shock Absorber for Yamaha Raptor 660 660R 700 700R

Front Air Shock Absorber for Yamaha Raptor 660 660R 700 700R

This pair of 425mm front air shock absorbers is designed to replace worn or damaged front suspension units on Yamaha Raptor sport ATVs, restoring proper ride height and damping control.

Overview

These front air shock absorbers fit Yamaha Raptor 660, 660R, 700, and 700R models, measuring 425mm (16.75 inches) in eye-to-eye length. The air-assisted design allows you to adjust spring rate and ride height without swapping springs, making them a practical choice for riders who want tunable front suspension. Each pair is built to bolt into the factory mounts on compatible Raptor models, making them an easy replacement for blown or tired factory shocks.

Built For Performance

• 425mm (16.75 inch) eye-to-eye length matches the stock front shock dimension on compatible Raptor models
• Air-assisted chamber allows spring rate and ride height adjustment without removing the shock from the quad
• Nitrogen-charged damping for consistent response over repeated impacts off-road
• Corrosion-resistant finish on the body and eyelets to withstand mud, water, and trail debris
• Sold as a matched pair, so both front corners receive the same valving and spring rate
• Rebuildable design for long-term serviceability with common shock tools

Fits These Machines

• for Yamaha Raptor 660
• for Yamaha Raptor 660R
• for Yamaha Raptor 700
• for Yamaha Raptor 700R

On-The-Job Use

• Trail riding where the front end needs to soak up roots and rocks without wallowing
• Dune riding where air pressure can be tuned for load and terrain
• Track and field racing on Raptor sport quads
• Replacing a set of leaking or seized factory shocks on a project quad
• Refresh of a high-hour machine before resale or a full suspension rebuild

Specs At A Glance

Good To Know

Q: Do I need to set air pressure before installing these? A: Yes, the air chamber is what sets the spring rate, so start at the low end of the pressure range and add until the front end sags correctly under the quad's weight. Adjust in small increments with a proper shock pump.

Q: Will these bolt straight onto my Raptor without modification? A: They are built to the stock 425mm eye-to-eye length for the listed Raptor models, so they should mount to the factory eyelets without modification. Confirm your model and year before ordering since suspension specs can differ between trims and production runs.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.