Pair Mirror For 2019-2024 Chevy Silverado 1500 W/ Power Glass Heated Temp Sensor

Mirror Pair for Chevy Silverado 1500

This pair of side mirrors fits 2019 to 2024 Chevy Silverado 1500 trucks and combines power glass adjustment with heated defrost and an integrated temperature sensor for year round driving confidence.

Overview

This mirror pair for Chevy Silverado 1500 delivers power glass positioning, heated defrost and a built in temp sensor in one complete set. Drivers replacing worn or damaged side mirrors get restored visibility and factory style function without paying dealer prices. Each mirror in the pair bolts to the factory mounting points for a clean, direct fit.

Built For Performance

• Power glass adjustment lets you fine tune the mirror angle from inside the cab
• Heated mirror surface clears frost, fog and condensation quickly
• Integrated temperature sensor feeds ambient readings through the factory system
• Durable housing stands up to road debris, weather and daily driving
• Matches the factory connector layout for straightforward plug and play wiring
• Sold as a pair to refresh both sides in one job

Fits These Machines

• for Chevy Silverado 1500 2019
• for Chevy Silverado 1500 2020
• for Chevy Silverado 1500 2021
• for Chevy Silverado 1500 2022
• for Chevy Silverado 1500 2023
• for Chevy Silverado 1500 2024

On-The-Job Use

• Daily commuting where clear side visibility matters
• Winter driving when frost and fog build up on the glass
• Towing when wider rear visibility is needed
• Replacing a cracked or non functioning factory mirror

Specs At A Glance

Good To Know

Q: Will both mirrors in this pair have the same features? A: Yes, this listing covers both the driver and passenger side mirrors, each with power glass, heat and the temp sensor built in. A: Both sides share the same connector style so installation stays consistent across the pair.

Q: Do I need any extra parts to install these mirrors? A: No additional hardware is required since these units bolt to the factory mounting points and plug into the existing connectors. A: Basic hand tools are usually all that is needed for the swap.

Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.