Pair Steering Rack Boots For Polaris RZR 800 2008 2009 2010-2014 5412012 5412013
Pair Steering Rack Boots For Polaris RZR 800 2008 2009 2010-2014 5412012 5412013
Couldn't load pickup availability
Steering Rack Boots for Polaris RZR 800
This pair of steering rack boots replaces OEM 5412012 and 5412013 on Polaris RZR 800 machines, protecting the steering rack from dirt, water, and debris.
Overview
These steering rack boots are a direct-fit replacement for worn or torn rack boots on Polaris RZR 800 side-by-sides. Each boot seals the rack ends to keep grit and moisture away from the internal components, helping preserve steering response. This pair is intended for riders and mechanics servicing 2008 through 2014 RZR 800 models.
Built For Performance
- Sold as a pair, covering both ends of the steering rack
- Cross-references OEM part numbers 5412012 and 5412013
- Flexible rubber construction resists cracking from heat and ozone
- Ribbed boot design allows full steering travel without binding
- Seals out mud, dust, and water that accelerate rack wear
- Fits 2008 through 2014 Polaris RZR 800 applications
Fits These Machines
- for Polaris RZR 800 2008
- for Polaris RZR 800 2009
- for Polaris RZR 800 2010
- for Polaris RZR 800 2011
- for Polaris RZR 800 2012
- for Polaris RZR 800 2013
- for Polaris RZR 800 2014
On-The-Job Use
- Trail riding where mud and standing water are common
- Routine rack maintenance during suspension service
- Restoring steering feel on high-mileage RZR 800 machines
- Preventive replacement before rack seals fail
Specs At A Glance
| Part Number(s) | 5412012, 5412013 |
| Quantity | Pair |
| Position | Steering rack |
| Material | Rubber |
Good To Know
Q: How do I know if my rack boots need replacing? A: Cracks, tears, or grease weeping from the boot ends are the usual signs, and torn boots let grit reach the rack internals. Inspect them whenever the front end is apart.
Q: Are clamps included with this pair? A: The listing covers the boot pair itself, so check your existing clamps and replace any that are stretched or corroded. Reusing sound clamps with a proper seal is standard practice.
Slight variation in finish or dimensions may occur between production runs, and fit can depend on serial number, so confirm compatibility before ordering.
Get it between -
Share
